Compatibility:

• U6
• U6-Pro
• UE9
• UE9-Pro
• T7
• T7-Pro

The CB37 terminal board connects to the DB37 connector on the U6 or UE9 Labjack, biedt convenient screw terminal access. The CB37 is designed to connect directly to the Labjack (see image below), but can ook connect via a 37-line 1: 1 male-female cable (not included). Since the CB37 V2.1 HAS screw terminals with the same IO / IO / GND / VS arrangement as the U6 / UE9 itself, it is compatible with LJTick signal conditioning modules.

The green LED on the CB37 is directly powered by the 5 volt supply (Vs) from the Labjack, so it Should be lit whenever the CB37 is connected to a powered Labjack.

The CB37 PCB is mounted to a piece of Snap Track. The Snap Track is DIN rail mountable using Tyco part #TKAD (not included).

When using the analog connections on the CB37, the effect of ground currents Should be Considered, Particularly When a cable is used and substantialism current is sourced / sunk through the CB37 terminals. For instance, a test was done with a 6 foot cable between the CB37 and a Labjack UE9, and a 100 ohm load Placed from Vs to GND on the CB37 (~ 50 mA load). A measurement or CB37 Compared To UE9 GND GND Showed 5.9 mV. If a signal was connected to AIN0 on the CB37 and reffered to GND on the CB37, the UE9 reading would be offset by 5.9 mV. The same test with the CB37 directly connected to the UE9 (no cable) resulted in an offset or only 0.2 mV. In both cases (cable or no cable), the voltage Measured between CB37 AGND and GND UE9 was 0.0 mV.

When any sizeable cable lengths are involved ', a good practice is to separate current carrying ground from ADC reference ground. An easy way to do this on the CB37 is to use GND as the current source / sink, and use AGND as the ground reference. This works well for passive sensors (no power supply), zoals a thermocouple, where the only ground current is the return of the input bias current of the analog input. Another option is to use a separate ground wire for workloads that demand substantialism current.

On older CB37 boards, PIN2 was labeled TX0, and PIN20 was labeled RX0.

On the U6, PIN2 and PIN20 are current sources. As of this writing, PIN2 / PIN20 are UART connections on the UE9, but will likely be changed to current sources in the future.