The LJTick-RelayDriver allows 2 digital I/O lines on a U3, U6, or UE9 to each control a relay or other moderate load.
Provides a pair of 14-bit analog outputs with a range of +/- 10 volts. Plugs into any digital I/O block, and thus up to 10 of these can be used per LabJack to add 20 analog outputs. Works with any UD family device (U3/U6/UE9), except for U3 hardware ...
This is a three foot DB37 cable, useful for all DB37 connections
The LM34CAZ is the most accurate version of the LM34 precision temperature sensor made by Texas Instruments. It has a very convenient output of 10mV per °F, so 0.78V would correspond to 78°F.
OEM board-only version of the LabJack U12, NTH Version
signal conditionning unit from 4-20 mA signals.
Provides convenient screw terminals for the DB15 connector on LabJacks. Includes a screwdriver.
Converts 3.3V digital outputs to 5V digital outputs. Easily control 5V relays, or interface with a 5V logic device.
The LJTick-Resistance (LJTRx) makes it easy for LabJack devices to measure resistive sensors.
Increases the output current of the DAC outputs on LabJack devices. Can also be used for switched 3.3V when attached to a 3.3V digital I/O line. LabJack devices cannot output more than about 15mA on their DAC0 and DAC1 analog outputs, so this accesso...
Labjack U6, 16+ bits of resolution, Wide input range, Amazing price performace ratio
T7-Pro-OEM from LabJack. OEM Version, PCB Only
Labjack U6-PRO, 24 bit sigma-delta AD, Wide input range, Amazing price performace ratio
PCB Board OEM version of Labjack U6-PRO, 24 bit sigma-delta AD, Wide input range, Amazing price performace ratio
Voltage reference accessory that outputs a stable 2.5V. Commonly used as an excitation voltage for various circuits. The IOA and IOB lines are pass-through terminals, and do not interact with the accessory in any way.
Very low bias current (1pA) input buffer which can directly measure pH sensors (electrode type sensors) and other weakly driven or high source impedance signals. The analog inputs on our compatible DAQ products (U3, U6, UE9, T7) have typical bias cu...
Voltage reference accessory that outputs a stable 4.096V. Commonly used as an excitation voltage for bridge circuits. Simply attach the supply side of the bridge to the 4.096 terminal, and ground to the GND terminal. The IOA and IOB lines are simply...
