PT1000, 4 wires, class A, 6 x 50 mm SS316 , and 10 meters silicone cable. - IP67
Tmax : 180°C
Sensor for temperature and humidity with dew point calculation. Comunication via RS485 line. Plastic enclosure with vent holes for interiors. To be mounted on wall or ceiling.
The WM-300 is a wall-mounting station that is built for use with the Cryo-Temp and LyoTemp. It can be mounted using the adhesive tape along the back or it can be screwed to a wall or any flat surface.
The HiTemp140-FP is a high temperature data logger with a flexible RTD probe and stainless steel tip. Includes ISO17025 accredited calibration certificate.
TCP2RTU is a transparent converter of the MODBUS TCP protocol running over Ethernet, into the MODBUS RTU protocol, running on RS232 lines.
TCP2RTU is a transparent converter of the MODBUS TCP protocol running over Ethernet, into the MODBUS RTU protocol, running on RS422 lines.
Intelligent digital RS485 sensor for temperature and / or humidity measurement.
The RFOT is a wireless meat temperature data logger. Includes ISO17025 accredited calibration certificate and micro USB cable
High Temperature Data Logger with a 24 "Flexible Probe
Interface Cable Package with Docking Cradle for the 140-Series Data Loggers.
Easy to use and very accurate temperature probe. Features a waterproof stainless-steel probe, a high-level linear output of 10 mV per degree F, a typical accuracy of ± 0.4 ° F (± 0:22 ° C) at room temperature, and a range of 0 to +300 ° F ( -17 to + 150 °
Provides a pair of 14-bit analog outputs with a range of +/- 10 volts. Plugs into any digital I / O block, and osmanthus up to 10 or thesis can be used by Labjack to add 20 analog outputs. Works with any family UD device (U3 / U6 / UE9), except for U3 har
Signal conditioning module designed to divide two single-ended channels or higher voltage analog signals down to 0-2.5 volt signals.
Labjack U6-PRO, 24-bit sigma-delta AD, Wide input range, Amazing price performace ratio
Labjack U6, 16+ bits of resolution, wide input range, Amazing price performace ratio
Industrial HART temperature transmitter for DIN-head mounting. Supports thermocouples and RTDs and converts temperature into a stable 4–20 mA signal. Universal input, high accuracy (±0.1 °C) and fully configurable via HART.
LynxPro-RTD - Bluetooth Enabled RTD Temperature Data Logger with LCD Display
LSB206 , S-Beam Jr.™ Fatigue Rated Tension & Compression Load Cell with UART / SPI Digital Output , M3x0.5-Thread , Overload Protection , 17-4 PH S.S. , RoHS , 32 Awg 10 Conductor Spiral Shielded Silicone Jacket , 6 in Long
PIMZOS In-line Cable Loadcell Converter, Output 4-20mA
LSB352 - Tension & Compression Load Cell , Rated Output (3 mV/V, 350 ohm) , Material - 17-4 PH S.S. , 1/2-20-Thread , Overload Protection , 4 Pin Lemo Receptacle, EGG.0B.304.CLL
Inclination switch ±45° with 4x PNP output
