Item No. MCP02500
Model: Thread Adapter M3x0.5 Male to M6x1 Male
PT100, 3 wires, class B, Mineral insulated, SS316, diameter 6 mm + Potseal 8 x 40 mm + spring + 2000mm PFA screened cable.
Thermal Shield for the HiTemp140X2 Dual Probe Data Logger.
The WM-300 is a wall-mounting station that is built for use with the Cryo-Temp and LyoTemp. It can be mounted using the adhesive tape along the back or it can be screwed to a wall or any flat surface.
High Temperature Data Logger with Fast Response Probe
The LNDS is a data logging system for ultra-low temperature monitoring. Includes standard calibration certificate.
High Temperature Data Logger with a 24 "Flexible Probe
Easy to use and very accurate temperature probe. Features a waterproof stainless-steel probe, a high-level linear output of 10 mV per degree F, a typical accuracy of ± 0.4 ° F (± 0:22 ° C) at room temperature, and a range of 0 to +300 ° F ( -17 to + 150 °
Easy to use and inexpensive temperature probe. Features a plastic probe, a high-level linear output of 10 mV per degree K, a typical accuracy of ± 1 ° C (± 1.8 ° F) at room temperature, and a range of -40 to +100 ° C (-40 to +212 ° F).
The LJTick-Proto (LJTP) Consists of an 8x8 grid of holes for prototyping custom signal-conditioning ticks. The 4-pin design plugs into the standard AIN / AIN / GND / VS screw terminal block found on newer LabJacks zoals the U3 and UE9. Includes three...
OEM board-only version of the Labjack U12
Module M1 with 1 analog output for signal retransmission in 4/20mA configurable as active or passive. Isolated. For instruments from Series C and Series MBR.
R-SG3 Load Cell Versterker ModBUS RTU + TCP-IP
LynxPro-RTD - Bluetooth Enabled RTD Temperature Data Logger with LCD Display
LSB206 , S-Beam Jr.™ Fatigue Rated Tension & Compression Load Cell with UART / SPI Digital Output , M3x0.5-Thread , Overload Protection , 17-4 PH S.S. , RoHS , 32 Awg 10 Conductor Spiral Shielded Silicone Jacket , 6 in Long
Panel meter for loadcell with 4 and 6 wires, 96 x 48 mm (1/8 DIN), 6- digits, 14 mm LED height, Power Supply 24VDC
PIMZOS In-line Cable Loadcell Converter, Output 4-20mA
IAA105 - Bluetooth & USB Configurable Full Bridge Strain Gauge Signal Conditioning Voltage Amplifier , Multiple Outputs Between +/-10 VDC , Up to 10 kHz Bandwidth , Detachable Screw Terminal Connectors , Metallic Enclosure , 35 mm DIN Clip
LabJack T8 - The new flagship DAQ from LabJack USA
Quido ETH 3/0 includes 3 digital inputs and thermometer. Quido connects directly to a LAN (Ethernet) and can be fully controlled and managed through a web interface. Inputs are designed to connect voltage or contacts – can distinguish two states (0 and 1)
Quido ETH 4/4 includes 4 digital inputs, 4 outputs and thermometer. Quido connects directly to a LAN (Ethernet) and can be fully controlled and managed through a web interface. Inputs are designed to connect voltage or contacts – can distinguish two state
